Zoning matters more than the thermostat
Swapping in a good-looking smart thermostat usually just shows you the problem more clearly. The real gain comes from zoning — splitting the house into areas that are controlled separately, so rooms nobody is using are not heated to the same temperature.
In a two-story house, separating up from down is almost always worth it. Heat rises, so in winter the upstairs runs hot while the downstairs stays cold, and no single thermostat can satisfy both.
Schedules should follow the household, not the clock
We set schedules around how you actually live, and we leave manual override on top. Working late or home early, a manual change wins for the rest of that day and the schedule resumes the next morning — you never have to undo it.
- Start dropping the temperature an hour before bed and let the building coast down.
- Come back up 40 minutes before the alarm rather than blasting the system at 6am.
- Set a floor temperature for empty periods instead of switching off, so pipes stay safe.
- Vacation mode holds a minimum and keeps reporting, so you can see the house from away.
Humidity — the half nobody manages
In winter the heat dries the air until your skin complains; in summer it sits heavy. The thermostat reads correctly and the room still feels wrong, because humidity is not being managed.
We add humidity sensing in the main living spaces and, where it is needed, tie in dehumidification or humidification so the system is working from both numbers rather than one.
Houses that sit empty
If this is a vacation property that goes unoccupied for weeks in winter, remote monitoring plus a low-temperature alarm is close to essential. The system tells you the moment the interior drops below your threshold — far cheaper than dealing with a burst pipe afterwards.
Can the existing equipment stay?
Mostly, yes. During the survey we check how the current system is controlled and what is wired where. If it can be reused, it is. We only recommend replacing the unit when its control interface genuinely cannot accept an external signal, and we explain exactly what the difference would be.